Discover update lights for the outside at skapetze®
For entrances, sidewalks or terraces, build-up lights are a welcome alternative to outdoor beams or bollards.
Bauen lamps outdoors are characterized by a flat construction and modern LED technology, which are nevertheless economical and bright, but are also able to defy the different weather conditions.
In our lighting online shop you will find various LED rectification lights for your home.
LED installation lamp for the outdoor area
The NON Plus Ultra are particularly upholstery lights with LED technology for the outdoor area. Thanks to the economical LED technique, the construction lamps can be used all night without worries without your wallet suffering too much. It is also possible to couple the mounting lights with motion detectors or sensor.
Thanks to the LED technology, a particularly high durability of the LED structure lamps is guaranteed. The lamp is therefore preserved for a long time. Whether in the private garden, in public access, entrances, parks or other outdoor facilities.
Raising lights 12V - we have the right system
Outside, high-voltage lighting systems are not always unproblematic. If children in the garden look for earthworms, the spade should not necessarily get on a 230 V line. For this purpose, there are low-voltage systems (12 V systems), in which an same procedure would be unproblematic.
Paulmann named Plug's 12 V up-up light system & Play offers protection when installing the assembly lamps and is very easy to assemble. Using the practical plug -in system, the lights can be connected and branched off via the numerous outlets. Exactly where you need the electricity, you get it too.
For bushes, trees, stone beds or walls, on which the garden lighting is to be staged, the power cable can be easily introduced. Structural lamps are also in the Paulmann Plug & Play series included and of course available in our advanced light range. Buy them together with the associated plug & Play starter set cheap and order very practical online in skapetze® Lamp shop.
How to assemble uphill lights? Here is a short guide:
The way you assemble your build -up lights on the outside first depends on the surface.
At the beginning, make sure that the electricity is switched off in the corresponding area (e.g. via the fuse box).
Whether wooden floorboards on the terrace or paving stones in the entrance, everything is possible. Use either the corresponding power cables to the desired areas before plasters and mark the places where the lights are to be positioned, with a colored marking or a metal stick in the adjacent area.
Make sure with a measuring tape or meter that the distances are all exactly the same. Now drill a corresponding hole with a drill and a drill suitable for paving. This usually works without any problems. Now assemble the assembly lamp onto the cable (usually using a phase tester and/or screwdriver).
Now continue the cable to the next lamp, etc. until you have recorded all the lights.
If you now turn on the electricity, the lights should burn.
In the fuse box, modules can also be installed with which the outer lights automatically tackle or go out at the time you have. The electrician of your choice takes on this installation directly from you on site. But you can also do that skapetzeContact ® assembly service.
Beating lights with IP44
Pay attention to protection class IP44 (splash -proof) when choosing your build -up lights. This is important so that when it rains or snow, no water can penetrate the assembly lamp. In our light shop you will only find protected construction spots that meet the German standard.
Beating lights advice
Do you have any questions about the right installation lamp? Then contact our service and we look for the lamp that is suitable for your needs. We also easily get upgrading lamps from other manufacturers who may not be in our range.
Now a lot of fun browsing and shopping skapetze®!
